Space Rover 2020 Challenge - Vexus Sol 250-ex

I am back with another update. I moved on with modeling the "SENUS" system that i talked about in First Episode. Than i will switch again with refining the front part of the vehicle. I am satisfied on how i am progressing with the vehicle.

"SENUS" system is almost done, just a few things to check before i call it done. 

Here is another update of my progress so far. 

Refining that back part of the vehicle where the drone hatches are. There are a couple adjustments to make to this back part and then i will create radar antenna.

Started with creation of the radar antenna. Progressing very good so far.

Adding more parts to the antenna and there is a lot more things to add. I am going really into detail with this one.

Here is another update on the radar antenna. I added that back support part that holds the antenna and allow it to rotate.

Yet another update on the radar antenna. It took me a lot of time to fully complete it. Now i will move on creating  lower back part of the vehicle.

Just a small update on the back part of the vehicle, i added charging docks, so through that it can be recharged with some kind of fuel. It has 16 charging pipes, that way it can refuel very fast. Also this is what i have done so far. Still a lot of things to be done but i hope i will make it in time 😀

Slowly getting the look i like for the back part. At the back there will be huge door to enter the vehicle. In there it can store small support vehicles and equipment needed for the exploration missions.